950mm width plastic pvc evaporative pads for cooling tower fill pack

Description:

Cooling Tower Fill provides sheets of material that are shaped into a corrugated pattern for the water to travel across. It can be combined and stacked into blocks, to create various thicknesses and heights to fit individual cooling towers.
The largest disadvantage of film fill is that it doesn't provide an opportunity for the water to redistribute itself. The initial water distribution at the top of the fill must be uniform, or the process won't work well. The close spacing created by the narrow passages of film fill also makes film fill more challenging to maintain. If the water includes large debris like leaves, the fill is prone to clogging.

* The fill is the most important part of the cooling tower, and its efficiency depends on the degree of sufficient contact between the cooling water and the air in the fill. The company's packing is temperature resistant

*  It is easy to install, easy to clean, and easy to transport. The heat dissipation packing adopts a non-adhesive suspension type, which is easy to install and easy to clean, and successfully solves the problem of the deformation of the adhesive packing due to dust accumulation and self-weight. , and the fouling after deformation is more serious and difficult to clean. The filler has good flame retardant performance. After testing, the flame retardant oxygen index index is greater than 28.

* The large "honeycomb" structure design has a diversion effect, which has a good uniform air distribution effect, improves and stabilizes the heat exchange intensity of water and gas, and the wind inlet end is inclined at an angle of 30 degrees, which effectively reduces the drift loss. The precise positioning and equal spacing combination is convenient to form a large-area flowing water film with the water flow perpendicular to the surface, which promotes the contact surface of the atmospheric air. , The unique and high-efficiency water eliminator is integrated with the packing, which effectively removes the water droplets in the hot and humid air and returns to the tower, which greatly reduces the loss of drifting water. The floating water loss rate is less than 0.001%.

Supply in industry

Cooling tower packing cleaning method:

1. Manual cleaning of the slag falling off in the cooling tower;

2. Rinse the packing repeatedly with a high-pressure water gun to remove the sludge and scale under cleaning;

3. Dissolve the TNB descaling agent with hot water at about 50°C, and then use the flushing pump to rinse the filler repeatedly until the scale is rinsed off (if the filler has a long service life, causing aging and collapse, it is recommended to replace the filler), and add algaecide at the same time. Completely kill biological algae and;

4. After confirming that all parts of the system are cleaned, drain the sewage;

5. Rinse the packing and the inside and outside of the tower body with clean water;

6. Restore all parts of the system, replenish water and use it;

7. After all recovery, please check and accept the management personnel of Party A;

8. Evacuate Party B's belongings and clean the site;

PACKING AND DELIVERY

About US

Q: Are you trading company or manufacturer ?
A: We are manufacturer with our own factory.

Q: How long is your delivery time?
A: Generally it is 5-10 days if the goods are in stock. Or it is 15-20 days if the goods are not in stock, it is according to quantity.

Q: Do you provide samples ? is it free or extra ?
A: Yes, we could offer the sample for free charge. And the freight cost will on the buyer's side.

Q: What is your terms of payment ?
A: Payment<=USD1000, 100% in advance. Payment>=USD1000, 30% T/T in advance ,balance before shipment.

If you have other questions, please feel free to contact us as below: